Super Quick and Easy Vintage Wreath Frame

*This post contains affiliate links. Which means I may receive a very small commission to go towards my blog maintenance.  It does NOT result in additional charges to you or cost you anything extra. See here for my full disclosure*

Supplies needed

• Wooden Frame – I used a 19″W x 24″ H
• Wax
• Christmas Wreath – I used a 16″ wreath from Kmart
• Vintage Style Tags– I found the ones I’m using in this project at the Dollar King but if you can’t find these I found some cute ones that are similar, just click on the link.
• Complementing Coloured Chalk Paint Mix- I used my Pewter Grey coloured Chalk paint.
• Grubbied up lace
• Jute
  
• Christmas Berries(optional if they are not already on your wreath)

Step 2 – Attach a variety of the tags to your wreath. The Christmas Berries were already attached to this particular wreath when I bought it, so you could add some at this stage if your wreath didn’t come with them.

Now it’s time for the fun bit!

Step 3– Lay your frame flat and then set the wreath so that it sits in the middle of the frame. Cut a piece of jute big enough to create a loop to hang your wreath without allowing it to hang outside the frame. Fasten tightly in a double knot. Take your piece of grubby lace and tie into a sweet bow and attach to the centre of your wreath.

Handy Hint– To achieve the grubby look, simply soaked the lace in a little bit of coffee and let dry.

Now your wreath is all ready to hang somewhere special in your home to enjoy this Christmas!

I hope you enjoy!

Until next time,

Don’t have time to make now? Be sure to PIN for later 🙂